mirror of
https://github.com/freedombox/FreedomBox.git
synced 2026-02-11 08:23:49 +00:00
9890271da4
Signed-off-by: James Valleroy <jvalleroy@mailbox.org> Reviewed-by: Sunil Mohan Adapa <sunil@medhas.org>
53 lines
2.0 KiB
Plaintext
53 lines
2.0 KiB
Plaintext
== pcDuino3 ==
|
|
|
|
{{attachment:pcduino3s.jpg|LinkSprite pcDuino3S|width=682,height=310}}
|
|
|
|
[[https://www.linksprite.com/linksprite-pcduino3s/|LinkSprite pcDuino3S]] is a single board computer running on Allwinner A20 and sold with a good case. !FreedomBox images are built and tested for this device.
|
|
|
|
Note: The !FreedomBox logo is simply a sticker on top of device brought from store.
|
|
|
|
'''Important:''' Read [[FreedomBox/Hardware|general advice]] about hardware before building a !FreedomBox with this single board computer.
|
|
|
|
|
|
=== Similar Hardware ===
|
|
|
|
Although untested, the following similar hardware is also likely to work well with !FreedomBox.
|
|
|
|
* [[https://www.linksprite.com/linksprite-pcduino3/]] also covers pcDuino3B
|
|
|
|
=== Download ===
|
|
|
|
!FreedomBox disk [[FreedomBox/Download|images]] for this hardware are available. Follow the instructions on the [[FreedomBox/Download|download]] page to create a !FreedomBox SD card, USB disk, SSD or hard drive and boot into !FreedomBox. Pick the image meant for pcduino3.
|
|
|
|
An alternative to downloading these images is to [[InstallingDebianOn/Allwinner|install Debian]] on the APU and then [[FreedomBox/Hardware/Debian|install FreedomBox]] on it.
|
|
|
|
=== Availability ===
|
|
|
|
* Price: 89 USD
|
|
* [[http://store.linksprite.com/pcduino3s-a20-single-board-computer-no-power-supply-or-hdmi-cable/|LinkSprite]]
|
|
* [[http://www.linksprite.com/buy-2/|Full list of suppliers]]
|
|
|
|
=== Hardware ===
|
|
|
|
* Open Hardware: No
|
|
* CPU: !AllWinner A20 SoC, 1GHz ARM Cortex A7 Dual Core
|
|
* RAM: 1 GB
|
|
* Storage: SD card, 4 GB onboard flash
|
|
* Architecture: armhf
|
|
* Ethernet: 10/100 Mbps
|
|
* !WiFi: Built-in WiFi requires non-free firmware, use a [[FreedomBox/Hardware/USBWiFi|USB WiFi device]] instead
|
|
* SATA: 1 SATA host socket
|
|
|
|
=== Non-Free Status ===
|
|
|
|
* Non-free blobs required: No
|
|
* !WiFi: Requires non-free firmware
|
|
* Boot Firmware: [[https://linux-sunxi.org/BROM|BROM]] (GPLV2+)
|
|
|
|
## END_INCLUDE
|
|
|
|
<<Include(FreedomBox/Portal)>>
|
|
|
|
----
|
|
CategoryFreedomBox
|