From 15f4e819724006f52b9468b3b6a176460682fd59 Mon Sep 17 00:00:00 2001 From: Antoine Poinsot Date: Thu, 27 Jun 2024 14:21:41 +0200 Subject: [PATCH] doc: slight improvement to Jade documentation --- doc/signing_devices.md | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-) diff --git a/doc/signing_devices.md b/doc/signing_devices.md index f31dca90..b6547432 100644 --- a/doc/signing_devices.md +++ b/doc/signing_devices.md @@ -40,11 +40,13 @@ Version 1.0.30 of the firmware is supported for use in P2WSH descriptors. Support for use in Taproot descriptors is not yet available in the firmware. -After the setup of the device, the first connection to set the pin will set also the network. -The network cannot be change unless doing a factory reset. +WARNING: You won't be able to connect your Jade to Liana if you choose "QrCode" mode when setting up +your Jade. This is because in this mode the Jade refuses to communicate through USB. -If using "QrCode" mode, the device will refuse other communication channels like USB. +WARNING: the network cannot be changed after setting up the device without a factory reset. The +network is set at the same time as the PIN. -If using "Temporary Signer", the first connection through USB will setup the network, a new session -is required in order to change it. If using the Liana gui installer, is is advised to first choose -the network before connecting the Jade in "Temporary signer" mode. +It is sometimes useful to change the network without a factory reset, such as when testing the +device and/or Liana. In this case the "Temporary signer" mode may be used. The network can be reset +by simply disconnecting and reconnecting it. If using this mode, we advise you to first choose the +network in the Liana installer before setting up the network on your Jade.