diff --git a/DBus-service.md b/DBus-service.md
index c931217..6513633 100644
--- a/DBus-service.md
+++ b/DBus-service.md
@@ -39,6 +39,35 @@ Example with `dbus-send`:
     dbus-send --session --type=method_call --print-reply --dest="org.asamk.Signal" /org/asamk/Signal org.asamk.Signal.sendMessage string:MessageText array:string: string:RECIPIENT
 
 
+### Multiple system buses 
+
+As an extension to [System Bus](DBus-service#system-bus), you can run multiple daemons with different bus names by providing the `--busname` parameter. In this guide we use the bus naming scheme 'org.asamk.Signal_NUMBER' where NUMBER is the user number **without** the leading + sign.
+
+Again, the following steps assume you created a user named *signal-cli*.
+For each (named) system bus, a config file is needed to allow the signal-cli user to take a name on the system bus. An template config file can be found in `data/org.asamk.Signal_NUMBER.conf`. This file also configures that any user can talk with the signal-cli daemon.
+
+The `data/signal-cli@.service` file configures a systemd service template that takes the NUMBER as argument. We start each service when systemd's _multi-user.target_ is reached.
+
+Executed these commands **once** as root to provide the signal-cli systemd service:
+```bash
+sed -e "s|%dir%|<INSERT_INSTALL_PATH>|" data/signal-cli@.service > /etc/systemd/system/signal-cli@.service
+systemctl daemon-reload
+```
+Mind the fact that signal.service executes the signal-cli with "--config /var/lib/signal-cli".
+If you registered with user signal-cli, remove the config option.
+
+Executed these commands **for each number** as root to provide the corresponding dbus configuration:
+```bash
+sed -e "s|%number%|<INSERT_YOUR_NUMBER>|" data/org.asamk.Signal_NUMBER.conf > /etc/dbus-1/system.d/org.asamk.Signal_<INSERT_YOUR_NUMBER>.conf
+
+systemctl reload dbus.service
+
+systemctl enable signal-cli@<INSERT_YOUR_NUMBER>.service
+systemctl start signal-cli@<INSERT_YOUR_NUMBER>.service
+```
+Make sure to use "--dbus-system" and "--dbusname 'org.asamk.Signal_NUMBER'" with the send command.
+
+
 ### Receive messages from signal-cli daemon
 The signal-cli daemon publishes new messages to dbus.
 Here's an example using python: